50 Watt Amplifier

This is a handy, easy to build general purpose 50 watt amp. The amp has an input for a radio, TV, stereo or other line level device. It also has a phono input for a record player, guitar, microphone or other un-amplified source. With the addition of a low pass filter at the input, it makes a great amp for a small subwoofer.

Schematic

Parts

Part Total Qty. Description Substitutions R1 1 200 Ohm 1/4 W Resistor R2 1 200K 1/4 W Resistor R3 1 30K 1/4 W Resistor R5 1 1K 1/4 W Resistor R6 1 5K 1/4 W Resistor R7,R10 2 1 Meg (5%) 1/2 W Resistor R8,R9 2 0.4 Ohm 5 W Resistor R11 1 10K Pot R12,R13 2 51K 1/4 W Resistor R14 1 47K 1/4 W Resistor C1 1 100uF 35V Electrolytic Capacitor C2 1 0.011uF Capacitor C3 1 3750pF Capacitor C4,C6 2 1000pF Capacitor C5,C7,C8 3 0.001uF Capacitor C9 1 50pF Capacitor C10 1 0.3uF Capacitor C11,C12 2 10,000uF 50V Electrolytic Capacitor U1,U2 2 741 Op Amp U3 1 ICL8063 Audio Amp Transister Driver thingy Q1 1 2N3055 NPN Power Transistor Q2 1 2N3791 PNP Power Transistor BR1 1 250 V 6 Amp Bridge Rectifier T1 1 50V Center Tapped 5 Amp Transformer S1 1 SPST 3 Amp Switch S2 1 DPDT Switch F1 1 2 Amp Fuse SPKR1 1 8 Ohm 50W Speaker MISC 1 Case, Knobs, Line Cord, Binding Posts Or Phono Plugs (For Input And Output), Heatsinks For Q1 And Q2 Notes Distortion is less than 0.1% up to 100HZ and increases to about 1% at 20kHz. I haven't been able to find anyone who sells a suitable T1. You can always use two 24V 5A units in series. If you are building two amps (for stereo), then I would suggest using an old microwave transformer and rewinding it. Follow the instructions in the 12V To 120V Inverter, execpt wind 26 turns, twist a loop (center tap) and wind 26 more turns. That should work out to around 50 volts. You may need to add or remove turns depending on your transformer. Q1 and Q2 will require heatsinks.